Many owners of the home, parquet spend a few years after it lost its luster surface, if re-buy is spending too much, this time a lot of people will choose to be refurbished wood flooring, that can be refurbished it? Parquet it can be refurbished? It depends on the thickness of the surface layer of wood flooring, because sanding will certainly reduce the thickness of the surface layer, every polished 1-2 mm thickness will probably wear off, if the surface layer is not thick enough, worn parquet surface grinding out the middle layer, bound to affect the life of the floor.
Market, multi-layer parquet surface layer is generally in the range 0.6-1 mm, thickness of the surface like this is not carried out renovation. The three-layer parquet surface layer thickness of most products is about 4 mm, so that after the renovation will not affect the floor in the middle layer. Therefore, renovation of parquet can do, be sure to determine the thickness of the floor surface, not blindly start. Since the parquet floor only surface wear flowers, wood is still the good wood, especially after years of use, parquet flooring has lost its luster, refurbished just polished off the surface of 1-2 mm on the floor, so the floor than to buy new much cheaper. Some well-known manufacturers offer wood floor renovation of this business, the processing fee is tens of dollars to the hundred dollars. ???
If they renovated, it is the first polished. 1, the use of large floor renovation sanding machine several times to remove the paint, surface, wood layer of about 0.5 mm, and then by carefully sanding the floor surface so delicate, smooth to a whole new state. Floor corner using a small angle grinder for grinding to achieve the overall smoothing effect. 2, the original seam transparent putty removed, re-sealed seam, and then the entire surface of the floor sealed primer to be dry. 3. After the primer dry, brush finish first pass, until dry. 4, water sandpaper carefully polishing the surface somewhat rough ground to remove the powder. 5, according to the above procedure three or four times paint brush, and finally do not have to grind again. 6, to be the last time after all dry finish marked the wax can.