1, line: see the foundation plan carefully, and then press the instructions on the map digging crossed.
6, Raymond Mill
hosts place: because the host is possible to install the central axis of the lifting process of channeling the host, so to determine whether the host central axis Shangcuan couplings found less than 25mm gap between the top and the lid when it Help Center has been channeling axis, this time you must beat with a sledgehammer plum middle rack side of the center axis reset. Otherwise, when the gear is fixed in place beneath the coupling halves host and activities reducer coupling half above 5mm gap due to leave for the illusion of reality. When the host job to a certain time in the future, under the action of gravity center axis reset, then the gap between the two coupling halves are top dead eliminate host load is too large to afford materials, low yield, the host vibration. There may even make gear casing to rupture. So, after a host in place, we must act to check the gap between the two coupling halves as shown in Fig. Host base alignment with horns, with box-type level meter school level, a host of vertical and horizontal level requirements within 1000mm of not more than 0.1mm, different axes of the two halves of the coupling is not greater than 0.3mm, the two coupling halves gap maintained within the range of 5-8mm, non-parallelism of not more than 0.1mm. Blower housing (fitted tees) to host the return air box inlet cavity as a benchmark and the blower cabinet seat ethos. You can place a second time after filling with female characters specifications for the second time when filling near the bottom plane of the host base: 300 × 300 plates of varying thickness at each bolt pad at the host, and the water fills up the mud the shelf life of only 18 days after the boot.
2, digging: by digging the instructions on the chart to ensure that the requirements of the focus position of the host where the digging depth, the depth of the remaining positions can be determined based on their own ground reality.
3, elevation and discharge mode: after the pit dug, according to the instructions on the basis of a good icon elevation respective position height.
4, put the mold fabric reinforcement: The host bolt hole cloth good ribs, and the rest according to the discretion of local realities.
5, pouring concrete: to ensure that more than 400 cement grade, when the concrete is poured into the mold release note elevation position and to ensure that the relative size of each position. Wooden mold pouring checking whether the shift will have to be corrected in a timely manner if there is a wooden mold displacement. After adjusting the positional relationship between the right to continue pouring with vibrator constantly vibrating vibrator to ensure its quality, if it is frozen heating season must have measures after pouring maintenance period for 12 days.
7, grading machine and pipe installation: press (see the supporting frame chart) do grader support frame and supporting frame whirlwind press (Figure 1) shows the position to put away the supporting frame, lifting classifier and cyclone collector on on the corresponding bracket, Figure 1 connected the pipe. .