reviews for spruce privacy wood lattice direct impact on the quality of living and housing overall appearance. So during the inspection room, wood floor fitting room full acceptance is the acceptance process is an important part. According to professional home inspector introduction: currently furbished wooden floor is quite conspicuous. First, look at the color of wood flooring are the same if the color is too large, directly affect the appearance, you can ask exchange; if the color is too uniform, almost no color, it is the floor pattern depends on whether the same surface. If the pattern is almost the same, then there may be craft wooden floor, rather than the so-called precious wood species of wood flooring material. Now, some wood flooring material suppliers, using the general wood material wooden floor, but in the surface layer of valuable wood species attached to shoddy veneer, with aluminum foil and paste it negative, that is to moisture, in fact, afraid pattern seen inconsistent negative and positive.
Second, depending on whether there is sound inexpensive balcony high quality flooring. Acceptance on the wooden floor back and forth, the pace should be increased, especially in parts of the wall parts and openings to pay more attention and acceptance, the site found the sound to repeat the move, to determine the specific location of the sound, and marked. In that case, you can request removal of resurfacing. There are sounds of the site, construction workers are in the construction process, operation and use of non-standard material substandard caused. Mainly in non-standard operation is not firmly fixed keel; material failure is mainly reflected in the keel without drying. Some of the keel construction decoration and construction unit with without drying, the surface has dried traces, in fact, did not do.
Third, the moisture content of wood products depends on whether or not controlled at about 12 percent of the keel with high moisture content in the wood natural drying process volume will be reduced, resulting in loose. Once again, the acceptance wooden floor deformation, warping, acceptance method is to use two meters long ruler, leaning on the wooden floor, the flatness of not greater than 3 mm. Pumping a few more measurements, if the passing rate of 80% or more are deemed qualified, on the contrary, that is unacceptable. Sometimes we find a local bagging wood floor: If the floor is wood, it is because the spread is too tight or too dry wood (moisture content is too low); if it is laminate flooring, it is poor quality of the floor. So flooring bagging is a serious quality problems. Finally, depending on the surface of the wood flooring if there is termite eyes, cracks, scratches. Common is due to keel untreated, there are worms. Isochronous found moth eye, wood borers have been almost the same; cracks and scratches to see that. Specification: park benches built with treated lumber gap should not exceed 0.5 mm; scratches are mainly caused by rough decoration, as with waxing method still can not be repaired, it must be replaced.